Cylinder Style End pin, 4 conductor Stereo Jack, 1/4"
End Pin style Black Finish with nut and washer.
Thick panel design for Acoustic guitar
Cylinder Style for 1/4" jacks, 4 conductor, End pin Black finished jack.
Setup ready for soldering to your project
Cutout type 4 conductor jack.
TRS (tip, ring, sleeve) setup to have 2 separate lines plus ground and cutout.
Can be wire for separate piezo and magnetic outputs.
Requires 31/64" mounting hole.
Overall Length is 1 5/32" on thread and 2 3/8" body length including solder points and 3/8" extension beyond body.
End pin cap is separate and removal with nut and washer to allow for adjustment.
1/4" Stereo Jack setup
5/8" end pin collar on front of jack.
Requires soldering
This Product may contain a chemical known to the State of California to cause cancer and/or birth defects or other reproductive harm. For more info go to www.P65Warnings.ca.gov
The parts on this site are made by or for Bitterroot Guitars.
These parts do not originate from the original OEM manufactures unless specifically identified as such.
Fender®, Strat®, Stratocaster®, Esquire®, Telecaster®, Tele®, Jazzmaster®, Jaguar®, Mustang®, P-Bass®, and J-Bass® are registered trademarks of Fender Musical Instruments Corporation.
Gibson®, Epiphone®, Les Paul®, S.G.®, Flying V®, ES-175®, ES-335® and P-90® are registered trademarks of Gibson Guitar Corporation
Kluson® is a registered trademark of W.D. Music Incorporated
LM®, SURELOCK® are registered trademarks of LM Products Company Incorporated
Lock-It® is a registered trademarks of Musical Distributors Group
Martin® is a registered trademark of Martin Guitar Company
S.I.T. Strings® is a registered trademark of S.I.T. Strings Company, Incorporated